Sprocket change (possible oopsie)
I purchased a 2015 FJ a few weeks ago and it needed a new chain / sprockets. All went well except for two things:
The front sprocket came off easily, but the new one (sprocket center) would seat and I had to hit it with a small wood mallet a few times to get it seated, but I'm not sure it seated all the way. I assumed torquing the nut would seat it. See below. Is this normal / will it wear over time?
Also when I was replacing the rear brake, the front bolt wouldn't threa
It was a D.I.D. VX3 chain, it looks like it will be close.
Paranoia got the best of me so I worked the sprocket off by hand. There was some dirt / grease underneath and it left some marring on the drive shaft. Honestly I think it is OK, it just looks like it is at the edge of the specification. I'm going to see if sprocketcenter will swap it out. I put the old sprocket on and it was significantly more easy to assemble.
I think the rear caliper issue was brake grease getting on the
