Jump to content

Installing Side Case and Trunk Lock Set


Recommended Posts

I did the same. Hard to describe but the little bar comes off by removing the security torx screws. Remove the two screws and place the tumbler (round cylinder) into the slot on the case. It will only fit one way. Reinstall the bar and you are done. The only thing you have to pay attention to is the direction the bar goes on as you can get it backwards. Takes like no time at all. Also on side note it's super not hard at all to key the ignition key to the lock set on the cases. Trust me if I can do it anyone can.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×