Jump to content

FJ-09 Ram Mount for GPS, iPhone, etc.


Recommended Posts

I'm going to try the lower bolts. I didn't on the first go around because I liked the fact that the upper ones are the ones that have no gaps to pinch.

Ken, Candy Ass L.D.R. Sleeps 8 hours
(2)2005 FJR1300abs:  230,000 m
2015 FJ-09:  106,000 m (Lost compression in #2 Cyl.)

Link to comment
Share on other sites

  • Premium Member
I believe I read it in the manual and the installation is the same as on my fz1. You loosely tighten the forward bolts down first till the upper and lower clamps touch, then the rear bolts. You end up with a gap on the back side of the clamps. It didn't look right to me the first time I did it but it is.
Bill
2015 Heeled by the hands of Nel's @ 2WheelDynoworks
K-Tech forks and shock
lots of other expensive unimportant stuff.
The "Ex" 2003 FZ1
Ride more, worry less.
 
Link to comment
Share on other sites

Typical Yamaha design for handle bars. After the fixed end is tighten, the second end has a gap and becomes like a pinch bolt, like on the front axle. This is typical in axle design on drive shaft bikes too.

Ken, Candy Ass L.D.R. Sleeps 8 hours
(2)2005 FJR1300abs:  230,000 m
2015 FJ-09:  106,000 m (Lost compression in #2 Cyl.)

Link to comment
Share on other sites

  • 4 weeks later...

Archived

This topic is now archived and is closed to further replies.


×