maxfnz

... when it comes with hand-written assembly notes (mine is #53)

Had my 2018 apart for a cannisterectomy (prelim to a Scottoiler) and while I was in the area located the plugs for the factory heated grips - in the left front wiring box - and if you're looking to add aftermarket grips but want to use the inbuilt 3-step Niken controller, they come out at 2ohms resistance each HTH Max

Late reply but might help others ... just put the GIVI led kit on mine, and - definitely check ALL the little wiring grub screws - pry off the covers if you can't get to them. My preassembled ones were all barely tight, not good. Blue loctite is your friend on these! - fine led wires into thelid plug are a PITA. I carefully cut down/notched the non-mounting side for better access - you may find your install to be intermittent between the box and the mounting plate contacts - try holding the brake on & jolting the topbox lower half. It seems the Givi tolerances here are really tight, and even with the spring-loaded contacts in the bottom of the topbox its still at the mercy of the rubber pads holding the box away from the plate. To fix, I popped the contact 'plug' in the mounting plate partially out & stretched a ~2mm thickness ?15mm dia oring over it & under its bearing lip (lip around edge so it can't push all the way thru) ... The extra height means LEDs don't go out when knocking the box bottom around