Jump to content

Cure for the stock mirrors

Recommended Posts

I took the bar end mirrors from my FZ-07 before I traded to the FJ-09. The mirrors are the CRG Arrow brand and the bar end adapters are from Rhinomoto and they screw directly into the internal thread in the FJ-09 handlebar. They are expensive but they are the highest quality aftermarket mirrors I have found. They never go out of adjustment and no vibration whatsoever. 
The handguards do have to be removed however.
Here is the link to the barend ... http://www.solomotoparts.com/RhinoMoto-Bar-End-Slider-for-Threaded-Mirror-Mount-for-FZ1-6-6R-01-13/
Here is the link to the CRG Arrow brand mirrors ...http://www.solomotoparts.com/CRG-Arrow-Bar-End-Mirror/
Link to comment
Share on other sites

  • 1 year later...
  • Premium Member
Images don't show, why not just click on the "Add image to post!" button right under Quick Reply and add the images that way?
Link to comment
Share on other sites

I would like to see them as well... do they work with FZ-09 bar ends?
EDIT: Disregard I see the kind of bar ends you posted.. look good, but you are right, kinda pricey...

'15 FJ-09 w/ lots of extras...

Fayetteville, GA, USA

Link to comment
Share on other sites

I too run CRG's on the FJ, a vestige from my past bike. Yes, you do need to look down slightly to view but I've gotten so used to it that I only ran with the "stock" height mirrors for a few weeks before switching. I think you could run CRG's with the stock hand guards ( using the cylinder at the very end of the bar ) but I also run the KTM guards ( again, from old bike ) which seem to provide better wind protection. I'll look around for a picture as the bike is currently "in storage" and unavailable for a photo-op.
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.