3way Posted September 14, 2018 Share Posted September 14, 2018 Fitting heated oxford grips. So, I've removed guards and ally type ends. Screwed into bar is an internal threaded insert, which looks a hex socket but not sure ? Has anyone got the size and type of this ? A 12mm alen wrench is fairly snug, Throttle side grip was bigger internally so went right over, but on clutch side it's same diameter as bar, and this insert has a bigger circumference so will need removing. Link to comment Share on other sites More sharing options...
jonno12345 Posted September 14, 2018 Share Posted September 14, 2018 I used a 12mm hex (allen) on a socket drive. An allen wrench should work fine. Link to comment Share on other sites More sharing options...
3way Posted September 14, 2018 Author Share Posted September 14, 2018 Thanks jonno Link to comment Share on other sites More sharing options...
3way Posted September 15, 2018 Author Share Posted September 15, 2018 Removed with 12mm hex. Poured hot water on handlebar, and insert came out with very little resistance. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.