bgigharbor Posted June 23, 2016 Share Posted June 23, 2016 I swapped in a new roadtec 01 in the rear today in place of the stock. Noticeably narrower and I think taller although that I did not measure. Turns out my newish no mar ch200 will not grab the fj09 17 inch rear rear. No settings on the grab blocks quite work. It's between sizes as far as I can tell. Maddening I can tell you because I could not grab the wheel securely. Once the tire was off the issue was very clear. Any way while I was working I notice a rubber plug on the ground. I am guessing that it goes as a spacer/gasket in the hole for the front mounting bolt of the rear calipers. Seem right?[/img] Link to comment Share on other sites More sharing options...
ilanr1 Posted June 25, 2016 Share Posted June 25, 2016 Do you have a picture of it ?. Thanks Link to comment Share on other sites More sharing options...
bgigharbor Posted June 25, 2016 Author Share Posted June 25, 2016 Do you have a picture of it ?. Thanks This is where I guessed it went. It's the black plug towards the right of the brake mounting bracket in the picture. Link to comment Share on other sites More sharing options...
ib Posted June 25, 2016 Share Posted June 25, 2016 Yes - that's where it goes. It's essentially a rubber gasket that protects the grease on the bolt that goes in there. The bolt attaches to the caliper and the bit that extends into the carrier has no thread so can slide in/out. The rubber gasket protects that section and keeps dust/dirt out of the grease. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.