catrike16 Posted January 31, 2017 Share Posted January 31, 2017 Hi All, I am part way through adding knuckle guard LED DRL's I have located the additional 12v sockets on the FJ09 and want to wire into these. How exactly is it done? Has anyone done it? The images are the end of the connector removed from the bike harness. It just plugs straight back in Link to comment Share on other sites More sharing options...
duhs10 Posted January 31, 2017 Share Posted January 31, 2017 Can't help you with this one! Hahaha... Good luck, I'm sure someone will give you guidance here... '15 FJ-09 w/ lots of extras... Fayetteville, GA, USA Link to comment Share on other sites More sharing options...
catrike16 Posted January 31, 2017 Author Share Posted January 31, 2017 Can't help you with this one! Hahaha... Good luck, I'm sure someone will give you guidance here...Ha, LoL, no worries, I think I have it sorted, need a couple of connectors that I'll pick up tomorrow? Link to comment Share on other sites More sharing options...
BBB Posted January 31, 2017 Share Posted January 31, 2017 I bought some connectors that looked similar, but didn't actually fit. However, they did have the correct inner terminals, so I pulled them out. If you look at your connectors under the windscreen, they have covers on, with no terminals inside. I put the terminals from my useless connectors inside the Yamaha covers and wired from there. Sorry, no pictures Red 2015 Tracer, UK spec (well, it was until I started messing with it...) Link to comment Share on other sites More sharing options...
catrike16 Posted February 1, 2017 Author Share Posted February 1, 2017 Hi, Same here, connector with no terminal, why? Well I just cut them, wired in with a 3M heat shrink connector. Job done! I'll post some pics tomorrow Link to comment Share on other sites More sharing options...
Premium Member builderbob Posted February 1, 2017 Premium Member Share Posted February 1, 2017 I used posi-taps and wired them into the power sockets. Easy. Link to comment Share on other sites More sharing options...
catrike16 Posted February 2, 2017 Author Share Posted February 2, 2017 The finished product? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.