ilanr1

Yes , i have the electronic version of the service manual gt version

Yes , i have replaced the main switch with the one from the Gt , this works with the ECU of the Gt. Right now i don't have a running engine. I just took the electronics from the Gt and right now I'm stuck. My bikd was working fine before this surgery...

Yes very ambitious , right now there is no spark at all of the plugs... , The immobilizer light goes off after turning the main switch to on. Is there a fuse that control the ignition ?. Or it looks like the ecu ?. The Gt that i bought was running , so i don't know what i connected wrong... I'll check all the fuses and the connectors tomorrow , any suggestions are welcome. Besides that the motor is not running , all is working on the colour display.. Thanks

Last update no spark...

Hi , I'm trying to switch to tracer 900 gt. I bought one after an accident , all the electronics are good and the engine. The throttle bodies are different so i need to replace them. I replaced the entire loom. Right now i have replaced all the electronics but the engine is not starting. The fuel pump is priming , the starter is good and strong. The blinking of the imobilizer is turned off after that i turn on the key. It looks like an electronic problem. Any thoughts ?. Thanks

Hi , i managed to take the throttle bodies out by shaking them front and rear directions. After a good clean i want to put them back again , it is not easy.. Is there a method or a trick how can I do that ?. Thanks

Thanks a lot , it works. 👍

Hi , i opened the fuel tank lock and i want to take out the key without shutoff the cover , where i can find the hidden pin ?. Anyone knows that ? Please share. Thanks

Hi , i want to make a good service and take out the throttle bodies , do i need to take out the injectors too ?. Thanks

Use configuration #1 only it's better in any way than the others.

Hi , right now it's not leaking but i can see cracks in the lower rubber part and it looks that it will start leaking soon...

Hi , where i can find only the rubber replacement for this cap ?. According to the part list i need to buy the cap complete , and right now there are no international shipping... Thanks

People , we are talking here about brakes , it's no joke at all. Please see a mechanic or a service center soon !!!.

Hi , if you don't have a catalitic converter why do you need this lambda sensor ?. It's useless...

Hi , my thinking was at first just to pull the lambda sesor out of the exhaust and cover the hole with a blank cup. Later to make my own plug from the old lambda's plug , to measure the resistance on the wires and to solder the right resistor instead. Thanks

Hi , i have tracer 900 with full system Arrow no cat , 2015 model. Can i remove the lambda sensor and place a blank cup instead ?. Your advice please. Thanks

Just tried to get on of it and it's very high so i pass it...

Thanks i'll check it.

Ok , i will try with the bushings and see how it goes. Will update soon. Thanks

No it just started lately. I have the Andreanni cartridges for 3 years with no issues. Maybe it's the inner bushing ?

I'm not touching the brakes and when i hit an obstacle like a pavement i can hear a knocking sound from the left shock

Hi , i have noticed a knocking sound from the left shock , my internals are completely Andreanni not stock ones.. No leaking issue all is dry. I can definitely hear it over small bumps on the road. I'm going to disassemble it , what should i check ? Or in other words what could be defective ?. Thanks

Hi , the easy way to test your repair is just measure the resistance on the wires , it should be a few ohms...

Hi , can you share the list of parts+prices that you use in this project ?, I think that I'm going to do that too. Thanks

Ok , waiting for your update !!!